Tank Grips Application Guide

Careful preparation and application will ensure maximum performance in all environments and will ensure 100% satisfaction with your purchase.

• 1Clean surface thoroughly.

  Clean surface thoroughly. Use an IPA cleaner to remove all surface contaminants. Do not use methylated spirits/petrol/lighter fluid etc, as they leave behind a thin greasy residue.

• 2Ensure prepared surface is above 10°C. Gently heat the grip and your tank.

  Ensure prepared surface is above 10°C. Heat up the Eazi-Grip tank pad and the tank on your bike with a heat gun or hair dryer for the best results

• 3Peel back part of the release liner and apply firm pressure as peeling.

  Peel back part of the release liner then press the tank grip firmly onto the tank and slowly peel back the liner whilst applying the pad. Push down between the traction domes and take care not to trap air bubbles as you go. Apply using firm pressure as our adhesive is pressure sensitive. Once applied press down firmly taking extra care at the edges.

• 4Leave for 48 hours.

  Leave for 48 hours for a full bond to develop before use.

Common Application Errors

• Surface is prepared using incorrect cleaner.
• Surface is cleaned using inappropriate material.
• Surface has recently been sprayed, painted. has new transfers or new logos.
• Surface is below application temperature.
• Tank grip is below application temperature.
• Surface has protective wax/polish/coating.
• Incorrect pressure applied during application.
• Tank grips used before full adhesive bond has formed.

Purchase Eazi-Grip

Disclaimer

Eazi-Grip™ Tank Grips are designed as a permanent application, and due to numerous factors that are out of our control, we cannot be held liable for any damage that may appear after removal.

Tank Grip Removal Advice